NTT docomo P-06C STYLE Series Instruction Manual page 16

■ List of materials used
Where it is used
Outer casing Display surface
Numeric key surface,
Display side surface,
Bottom part of display
panel,
Display back surface
Display back surface
Battery surface
(hinge side)
Back cover
Connector terminal
Connector Cover
terminal
Packing
Camera lens area
Side key
Around the side key
Charging terminal
Decorative area (Display back surface
※2
side)
Numeric key Key area,
surface Open/close stopper
Sheet area
14
Material/Finishing
PC/hard coating
PC + UV coating
※1
※2
PC/tin vapor deposition +
UV coating
ABS/UV coating
PC + ABS/UV coating
Stainless steel/
nickel plating + tin plating
PC, elastomer/UV coating
Silicon rubber
PMMA/hard coating
PC/aluminum vapor deposition
+ UV coating
ABS/UV coating
Brass/nickel plating +
nickel palladium plating +
gold plating
Crystal grass
Acrylic urethane
PET
Where it is used
Touch pen Body, Cap
Inside of cap, pen tip
Strap band
Call/Charging indicator
(Display back surface side)
Ring around the Call/Charging
indicator (display back surface side)
Corner area at the bottom part of the
display
Display panel
Tape (side surfaces of the battery
compartment)
Battery compartment surface
Battery Resin part
terminal
Terminal area
Battery pack Resin area
Label
Terminal area
UIM tray
Hinge area Center
Display back surface
side
Hinge support area
Cap
Flash part
Label (inside of the inner cover)
Label (outside of the inner cover)
Material/Finishing
ABS
POM
Polyester
Crystal grass
PC/tin vapor deposition +
UV coating
Elastomer
Grass/PET sheet
PET
Stainless steel/nickel plating
PA
Titanium copper/
nickel plating + gold plating
PC
PET
Glass epoxy substrate/
nickel plating + gold plating
POM
PA/UV coating
ABS/UV coating
PC
PET resin
PMMA/hard coating
PET
PEN