Call Delay; Programming The Call Delay - Sensaphone 1104 User Manual

4.8 Call Delay

Call Delay is the programmed length of time the Model 1104
waits, following detection of an alarm, before it begins the dial-
out sequence. This applies only to the first call. (Delay time
between calls is also programmable: refer to Intercall Time,
Section 4-11.)
The purpose for Call Delay is to allow time for personnel at the
Model 1104's installation site to respond to and cancel an alarm
before dial-out begins. During this time, the Model 1104 will
audibly repeat its "alert condition" message (unless the Local
Voice Mute feature has been activated—refer to Section 4.9). The
default for Call Delay is 30 seconds. Call Delay can be
programmed from 0 seconds to 60 minutes (1 hour).

4.8.1 Programming the Call Delay

To program the Call Delay:
1. Press SET.
SET
#
2. Press CALL DELAY.
1
CALL
DELAY
The Model 1104 will respond: "Enter minutes. "
3. Using the number keys, enter the minutes.
1
CALL
DELAY
4
MAX CALLS
7
RECOGNITION
TIME
The Model 1104 recites the digits as they are pressed.
4. Press ENTER. The Model 1104 responds: "Enter seconds. "
ENTER ENTER
TONE TONE
PM PM
Chapter 4: Communications Programming
2 3
INTERCALL
VOICE
TIME
REPS
5 6
TEMP LIMITS CALIBRATE
9
8
LISTEN TIME
CLOCK
SOUND
0
ID NUMBER
POWER
49