Programming Input Configuration - Sensaphone 1104 User Manual

Sensaphone ® Model 1104 User's Manual
For example, if a magnetic reed switch (a normally-
closed sensor used to detect unauthorized entry) has
been wired to the Model 1104, make sure that the
door or window to be monitored is shut before con-
figuring the input. If a motion-detector is wired to the
unit, it is advisable to block all sources of motion
from the sensor before and during configuration.

5.1.1 Programming Input Configuration

1. Press STANDBY to place the Model 1104 in Standby
mode.
2. Wire sensors to the inputs to the back of the Model 1104 (see
Chapter 2, Section 2.10).
3. Press RUN. The red light glows when the Model 1104 returns
to Run mode.
4. Press SET.
SET
5. Press CONFIGURE.
STATUS
CONFIGURE
6. The Model 1104 audibly recites the configuration for each of
the four inputs:
• If the input is normally open, the Model 1104 recites the
number of the input and says "OK. "
• If the input is normally closed, the Model 1104 recites the
number of the input, followed by a "beep" and "OK. "
• If the input is configured as temperature, the Model 1104
recites the number of the input, followed by "Temperature. "
64
RUN
STANDBY
RUN
STANDBY
#