Wireless Configuration - iCanTek iCanView 110 User Manual

iCanView110/110W User's Guide

5.4. Wireless Configuration

For the case of a network camera having built in wireless LAN it is needed to set up wireless LAN
configuration parameters. Click "Wireless Configuration".
Wireless LAN Setup
Set up parameters for wireless LAN.
- Use Wireless LAN : Select "Enable" to use wireless interface. If "Disable" is selected,
Ethernet interface is used instead of wireless LAN interface.
- SSID : Enter the ID of the wireless LAN access point to be connected, when wireless LAN
interface is selected.
- Use WEP : Select the mode of WEP. If WEP is not used select "Disable"
- Key Value : Set the value of WEP Key.
- Wireless Power : Set the maximum transmission power level of Wireless LAN.
WLAN Information
Information regarding wireless LAN interface is displayed.
- MAC Address : Indicates MAC address of the Wireless LAN card.
Figure 5-5 Wireless Configuration
Rev.1.4 (Jan. 2005)
28 of 56