Quick Installation Guide - iCanTek iCanView 110 User Manual

iCanView110/110W User's Guide
2.4. PC Requirements
AV streaming data from iCanView110 can be observed through i-NVR program which is a viewing &
recording program running on a PC. Minimum requirement of the PC is described below:
CPU
Main Memory
*
Operating system
Web browser
Resolution
Network
* Operating Systems supported : Windows 2000 Professional

2.5 Quick Installation Guide

Brief information for rapid installation is provided in this section. For more detailed information you
are recommended to refer to pertinent documentations provided with the product or refer to
iCanTek's home page (http://www.icantek.com)
1. Connect iCanView110 to your PC or network by using one of the following method
i. Connect your PC and iCanView110 using the Cross Type LAN cable provided with
iCanView110 or
ii. Connect iCanView110 and PC to same LAN using Direct Type cable.
2. Apply power to iCanView110
3. Install "IP installer" and "i-NVR" on your PC.
Detailed information for installing these programs can be found in
Guide] and [i-NVR User's Guide]
4. Assign IP address to iCanView110 using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
xDSL or Cable modem you need supplementary information provided by your ISP.
Minimum
Pentium III 700
128 MB
Windows 2000 or later
Internet Explorer 5.0
1,024 X 768
10 Base-T Ethernet
Windows XP Professional / Windows XP Home Edition
in this CD, respectively.
[IP-Installer User's
Recommended
Pentium IV 1.2G above
256MB above
Windows 2000 or later
Internet Explorer 5.0 above
Higher than 1,024 X 768
10/100 Base-T Ethernet
[IP-Installer User's
Guide]. If network type is
Rev.1.4 (Jan. 2005)
12 of 56