Sensor & Capture Setup - iCanTek iCanView 110 User Manual

iCanView110/110W User's Guide
5.7. Sensor & Capture Setup
This is the setup page for sensors and video capture conditions, which will be sent to user by FTP
or E-mail.
Sensor Setup : A sensor can be connected to iCanView110.
- Type Selection : Select sensor type. There are two types of sensors
. Normal Open : "floating" in normal situation, non-floating means an alarm condition.
. Normal Close : "non-floating" in normal situation. Floating means an alarm condition.
Video Capture Condition
1. Sensor initiated: when at least one of the sensor detects alarm condition.
2. Motion-Detection initiated : when motion is detected from video channel
Above 2 conditions are mutually independent in operation.
Sensor Select : Select the sensor that triggers video capture.
Motion Detection Select : Select the video channel that triggers video capture.
Captured Video Transmission
Figure 5-9. Sensor & Capture Setup
: It sets the condition of video recording and transmission via FTP or E-
mail. The iCanView110 supports 2 types of conditions :
: Select a way of sending captured video. You can send captured
video through FTP or E-mail, or both.
Rev.1.4 (Jan. 2005)
36 of 56