Honeywell CN75 User Manual page 102

Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
Before you set WPA-802.1x or WPA2-802.1x security with Funk security, you need
to configure your authentication server and authenticators. To use TLS protocol,
you also need to load a user and root certificate. On your computer, you need to
enable the radio and set the date.
1. Start Enterprise Settings.
2. Select Communications > 802.11 Radio > Funk Security.
3. Select a Funk security profile to configure.
4. Enter the SSID.
5. For Association, select WPA or WPA2.
6. For 8021x, select PEAP, TLS, TTLS or EAP-FAST.
7. If you selected TTLS, EAP-FAST, or PEAP:
8. If you selected TLS, enter a User Name and Subject Name.
9. Select Yes for Validate Server Certificate.
10. Tap OK.
Configure WPA or WPA2 Personal (PSK) Security with Funk Security
Before you set WPA or WPA2 Personal (PSK) security with Funk Security, you need
to know the pre-shared key for your access point or passphrase for your
authenticator. On your computer, you need to enable the radio and set the date.
1. Start Enterprise Settings.
2. Select Communications > 802.11 Radio > Funk Security.
3. Select a Funk security profile to configure.
4. Enter the SSID.
5. For Association, select WPA or WPA2.
6. For 8021x, select None.
7. For Pre-Shared Key, enter the pre-shared key or passphrase.
8. Tap OK.
90
The default encryption is TKIP for WPA or AES for WPA2.
a. For Prompt for Credentials, select Enter credentials now.
b. Enter a User Name and User Password.
The default encryption is TKIP for WPA or AES for WPA2.
• Enter the pre-shared key (0x followed by 32 hexadecimal pairs) for your
access point.
• Enter the passphrase (8 to 63 ASCII characters) for your authenticator. The
computer internally converts the passphrase to a pre-shared key.
75 Series Mobile Computer User Guide