Configure Leap Security With Funk Security - Honeywell CN75 User Manual

Configure 802.1x Security with Funk Security
Before you set 802.1x-WEP security with Funk security, you need to enable the
radio on your computer and set the date. To use TLS protocol, you also need to load
a user and root certificate. Honeywell recommends that you use WPA2-802.1x
instead of 802.1x-WEP if possible.
1. Start Enterprise Settings.
2. Select Communications > 802.11 Radio > Funk Security.
3. Select a Funk security profile to configure.
4. Enter the SSID.
5. For Association, select Open.
6. For Encryption, select WEP.
7. For 8021x, select TTLS, PEAP, or TLS.
8. If you selected TTLS or PEAP:
9. If you selected TLS, enter a User Name and Subject Name.
10. Select Yes for Validate Server Certificate.
11. Tap OK.

Configure LEAP Security with Funk Security

Before you set LEAP security with Funk Security, you need to enable the radio and
set the date on your computer.
1. Start Enterprise Settings.
2. Select Communications > 802.11 Radio > Funk Security.
3. Select a Funk security profile to configure.
4. Enter the SSID.
5. For Association, select Open, WPA, WPA2, or Network EAP.
6. For 8021x, select LEAP.
7. For Prompt for Credentials, select Enter credentials now.
8. Enter a User Name and User Password.
9. Tap OK.
75 Series Mobile Computer User Guide
a. For Prompt for Credentials, select Enter credentials now.
b. Enter a User Name and User Password.
The default encryption is TKIP for WPA, AES for WPA2, and WEP for Open or
Network EAP.
91