Using The Equipment Configuration Window; Accessing The Equipment Configuration Window - Lucent Technologies PacketStar User Manual

Chapter 3 Configuring and Controlling the Module Using the Console Interface

Using the Equipment Configuration Window

Using the Equipment Configuration Window

Accessing the Equipment Configuration Window

®
PSAX 4500 Alarm Module User Guide, Issue 1
PacketStar
3-8
5 Press Enter to change Deactivated to Activated (see Table 3-2 for
details).
The change in state lasts only 30 seconds, however the remote device
remains activated until it completes its task, for example cooling the
facility.
End
This section describes how to obtain product, model, version, and serial num-
ber data about a module from the Equipment Configuration window. In
addition, the window provides operational status and alarm conditions on
each installed module. You also use this window to access the port and chan-
nel configuration windows for the PSAX modules.
Perform the following procedure to access the Equipment Configuration win-
dow.
Begin
1 On the Console Interface Main Menu window, select the Equipment
Configuration option.
The Equipment Configuration window is displayed (see Figure 3-6 and
Figure 3-7). Table 3-3 describes the commands on the windows and
Table 3-4 describes the fields on these windows.
2 View the operational and alarm status, software version, PEC, and serial
number data of the installed modules.
3 Proceed to the section, "Configuring the Ports," for module configuration
procedures.
Note: The sample Equipment Configuration windows in the following
figures may not show the actual module you are configuring.
These figures illustrate the variations of slot configurations for
the different PSAX chassis displayed on the Equipment Configu-
ration window.
End
Release 10.0.0
255-700-598