Overview Of This Chapter; Before You Begin; Configuring The Alarm Module; Alarm Module Configuration Window - Lucent Technologies PacketStar User Manual

3
Configuring and Controlling the
Module Using the Console Interface

Overview of This Chapter

Before You Begin

Configuring the Alarm Module

Alarm Module Configuration Window

®
PacketStar PSAX 4500 Alarm Module User Guide, Issue 1
255-700-598
This chapter describes how to use the PacketStar
Gateways console interface in order to:
• Monitor the remote input status conditions and the states of the audible
alarms reported by the 4500 Alarm module
• Control remote devices connected to the 4500 Alarm module
Be sure to complete the following tasks first before configuring the 4500
Alarm module:
• Configure your basic system (see "Configuring the System for Your Site" in
®
the PacketStar PSAX Multiservice Media Gateway User Guide).
• Configure the Stratum 3–4 module (see "Configuring the Stratum 3–4
Module" in the PacketStar
When configuring the 4500 Alarm module using the console interface, dis-
play-only fields are displayed in square brackets ([ ]).
The 4500 Alarm module is configured by connecting cabling between the
module and the CO alarm panel, the remote ACO device, the environmental,
fire, or security sensors, and remotely controlled devices. Refer to Chapter 2
for details.
The Alarm Module Configuration window is used to monitor 4500 Alarm
module status inputs from up to 15 remote sensors, control up to 4 remotely
activated devices, and monitor the activity of the module's
remote CO ACO device (see Figure 3-1). Access the Alarm Module Configu-
ration window through this path:
Console Interface Main Menu window > Equipment Configuration
option > Equipment Configuration window > Page Down > Slot 25 Alarm
> Alarm Module Configuration window
®
PSAX Multiservice Media
®
PSAX Multiservice Media Gateway User Guide).
ACO switch and
Release 10.0.0
3-1