Psax 4500 Alarm Module Installation - Lucent Technologies PacketStar User Manual

®
PSAX 4500 Alarm Module User Guide, Issue 1
PacketStar
255-700-598
For newer PSAX 4500 chassis with the 10 rear blank faceplates already
installed, loosen the 2 captives screws on the blank faceplate in slot
with the Phillips screwdriver.
2 Remove the module from its box and ESD packaging only when you are
ready to install it. Be sure to save the box and the ESD packaging to ship
the module in the future if needed.
3 Open the ejector handle at the top of the module faceplate, and slide the
module into slot 14 (slots labeled along bottom edge of opening or fourth
slot from the left side facing the rear panel of the chassis). Be sure to
position the module with the ejector handle near the top edge of the
chassis opening.
4 Press on the ejector handle until it snaps firmly against the faceplate, and
verify that the module is secure in its slot.
5 Secure the module with the two captive screws on the faceplate using a
flathead screwdriver.
6 For the older PSAX 4500 chassis, secure the blank faceplates over the
uncovered slots (slots
Store the rear blank panel if necessary or dispose of it in accordance with
all local regulations. For newer PSAX 4500 chassis, store the blank face-
plate for future use.
4500 Alarm Module
3
17 16 15 14 13 12 11 10 9
Figure 2-10. PSAX 4500 Alarm Module Installation
7 For new installations, run the cabling through a cable management sys-
tem that provides the necessary connector/cable strain relief to prevent
damage to the module connectors.
Chapter 2 Module Description
, except slot ) as illustrated in Figure 2-10.
1–17 14
S
T
R
A
1 1 3 2
T
U
M
B A 8 7 6 5 4 3 2 1
Alarm Configuration Example
PSAX 4500 Rear Panel
Blank Faceplates
Installing the Module
14
3 1 2
1-Slot
2-Slot
3-Slot
Release 10.0.0
2-13