Removing The Module - Lucent Technologies PacketStar User Manual

Chapter 2 Module Description

Removing the Module

Removing the Module
®
PSAX 4500 Alarm Module User Guide, Issue 1
PacketStar
2-14
!
WARNING:
To prevent any damage to the module connectors, do not allow the
cables to hang unaided from the connectors. Use standard cable installa-
tion procedures to run and secure the cables through an appropriate
cable management system before connecting the cables to the modules.
8 Connect the
ALARM
plate connector.
End
Perform the following procedure to remove the 4500 Alarm module.
®
Read the PacketStar PSAX Multiservice Media Gateway Safety Guidelines, which
accompanies this product, before proceeding.
Removing the Module
Begin
1 Disconnect the cables from the two connectors, if applicable.
2 Using a flathead screwdriver, loosen the two captive screws near the top
and bottom of the faceplate.
3 Pull backward on the ejector handle until the module is pulled out of the
slot.
4 Place the module in ESD packaging and close it.
5 If a replacement module is not being immediately inserted into the
empty slot, insert a blank faceplate (See "Required Components to Install
the Module" on page 1-14 for blank faceplate part numbers.) into the
slot to prevent EMI and maintain proper air flow inside the chassis.
!
CAUTION:
Ultimate disposal of this product should be handled according to all laws
and regulations in your specific geographic region.
End
and cables to the appropriate face-
STATUS/CONTROL
Release 10.0.0
255-700-598