Table of Contents
Advertisement
1.6
Panel Mounting
1.
There is an adhesive waterproof gasket on the Mg front bezel. Make sure the
waterproof gasket is in position before installing TPC into the panel opening.
2.
Install the TPC into the panel opening.
3.
Find the clamps and long screws in the accessory pack. Hook the clamps to the
holes around the four sides of the bezel. Insert the screws in to every clamp and
fasten them. These screws will push the mounting panel and fix the unit.
4.
The suggested mounting panel thickness is less than 6 mm(0.236").
Insert the screws into each clamp and fasten
them
Hook the clamps into the holes
Fasten screws
Torque: 2 kgf-cm
These screws will push the mounting panel and
secure the unit
Figure 1.2 Panel Mounting
5
TPC-5000 Series User Manual
Advertisement
Table of Contents
