Low Pressure Lamps - ergoline BALANCE 700 HYBRID PERFORMANCE Operating Instructions Manual

12/2014 1015739-00
4.8.1

Low pressure lamps

DANGER!
Danger of burns from hot lamps and surfaces!
Finger and hands may get burned when replacing lamps.
– Before carrying out maintenance work, wait until the
device has cooled down sufficiently.
Replace faulty UV low pressure lamps immediately.

Always replace the entire set of lamps after the specified operating time.

– Turn 90° and carefully remove from the socket.
– UV and Beauty Light lamps have a reflector which directs the light out-
wards. The lamps must be mounted in such a way that the rear side of
the reflector is located on the device side.
– Push the pins vertically into the socket from above.
– When fitting the lamps, ensure that they are in the correct sequence.
NOTE:
The UV low pressure lamps do not fit in the coded lamp
sockets.
Non coded socket:
Cleaning and maintenance
Coded socket:
Operating instructions – 53/70