Samsung WEA453e AP Installation Manual page 95

WEA453e Installation Manual
Item
Grounding
Power
Supply
Other Data
Cables
Samsung Electronics America
Main Inspection
Checklist
the state of the
bolts/nuts/washers
Insulation status
Other installation
components, such as
the cable duct
installation status
Grounding bar
installation status
Cable standards
Cable installation and
binding status
Cable connection
status
Cable tag installation
status
Power supply
equipment and circuit
breaker installation
status
Cable standards
Cable installation and
binding status
Cable connection
status
Cable tag installation
status
Cable standards
Cable installation and
binding status
Evaluation Criteria
magnets if the tightening torque value
has been followed.
Check if there is any contact between
the insulators by performing an insulation
resistance test.
Locate and check each installation
status.
Check the separation status of the
Outdoor AP/power/arrestor grounding.
Check if the standards have been
followed, such as thickness and so on.
Check the damage/installed route/
bending radius of cables and the
materials used.
Check for the tightened and assembled
status of the pressure terminal and if the
tightening torque value has been met.
Check the location, labeling, and tag
installation method used.
Check the power supplying the
equipment's capacity/input voltage
(using a tester), and the circuit breaker's
type and capacity.
Check the thickness and limited distance
of the cables.
Check the damage/installed
route/bending radius of cables and the
materials used.
Check the power connection status for
each cable according to the pin map
configuration.
Check the pressure terminal/connector's
assembly and tightened status to
determine if the tightening torque value
has been met.
Check the location, labeling, and tag
installation method used.
Check the cable standards are correct
for each purpose.
Check the damage/installed route/
bending radius of cables and the
Version 1.0
Inspection
Results
Pass Fail
Page 95 of 117