Connecting A Power Cable; Figure 41. Power Supply Configuration; Table 20. Components And Tools For Connecting A Power Cable - Samsung WEA453e AP Installation Manual

WEA453e Installation Manual
3.4

Connecting a Power Cable

The power system consists of the following configuration:
Commercial
Power
Connecting a Power Cable
1) Prepare the following components:
Item
Installation
Section
Cables
Connectors
Required Tools
Samsung Electronics America
AC Distribution
Box

Figure 41. Power Supply Configuration

When handling power cables, ensure the power switch of the rectifier, and/or the
system, is turned off to prevent short circuits and electrical accidents.
An electrical accident can occur if fasteners become loose. Make sure the
fasteners that secure the power cable are firmly attached. Use a power cable that
has a temperature limit of 90°C or higher.
Make sure to consider the allowable curvature radius of a cable before you install
or cut the cable. If you cut a cable without considering its curvature radius, a
contact failure can occur after the cable is connected.

Table 20. Components and Tools for Connecting a Power Cable

Rectifier-Outdoor AP Power Input Terminal
AC Distribution Box-
AC/DC Adaptor
AC/DC Adaptor-Outdoor
AP Power Input Terminal
AC Distribution Box
Outdoor AP
Cable Cutter, Wire Stripper, Crimper, Heating Gun, Torque Driver (+), Torque
Wrench, and Nipper
AC
AC/DC Adaptor
Description
Power Cable Assembly-1 (100-240VAC)
Power Cable Assembly-2 (48 VDC)
Check the output port standards for the field and
prepare the connector.
- System Side: DY5F1203PNFL[JONHON]
- Cable Side: DY5T1203SNF[JONHON]
Version 1.0
DC
System
Page 62 of 117