WEA453e Installation Manual
3) Wrap the interlinked parts in at least two layers of insulating tape to cover the metal
after attaching the connector.
4) Wrap insulating tape over the area in at least two layers of butyl tape, starting 10-20 mm
down from the upper end to 10-20 mm below the heat shrink tube.
5) Wrap butyl tape over the area in at least two layers of insulating tape in the same
manner.
6) Tie both ends of the insulating tape using cable ties to make sure they do not become
unwrapped.
1
Samsung Electronics America
1
2
2
Insulating
Tape
Insulating Tape
Figure 8. Assembling the Dipole Antennas (2)
Version 1.0
Insulating Tape
3
Page 26 of 117