Table of Contents
Advertisement
Description
Operating the controller is possible in four different basic setups, see "Changing the
basic setup".
The status of the controller respectively of the connected accessories is displayed by
corresponding symbols on the LCD. After switching on the controller, the version of
the software is displayed, then the preselected basic setup. The solenoid operated
isolation valve is switched if connected (automatic identification), the cooling water
valve is switched, if the valve is configurated.
Display
setting pressure
or hysteresis
settings
basic setup
VACUU•LAN
Pressure reading
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 99 90 20 / 01/12/2004
page 7 of 36
countdown till switch off
pressure control
warning symbol
(in combination with other symbols)
pump symbol
isolation valve
cooling water valve
process control
active
selectable
pressure units
Hide quick links:
Advertisement
Table of Contents
