How To Work With The Controller - vacuubrand CVC 2 Instructions For Use Manual

How to work with the controller

How to change the pressure units
+
p
(mains switch)
Setting the cooling water valve (optional)
The controller switches a preselected cooling water valve.
A cooling water valve has to be configurated at the controller before starting the process see section
"Changing the basic setup".
It is possible to configurate the cooling water valve in all basic setups, see scheme above.
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 99 90 20 / 01/12/2004
page 10 of 36
Press key p▲ or p▼ while switching on.
☞ The pressure units are displayed, the pressure unit as from
mbar
last operation is flashing.
Torr ➨ Press key p▲ or p▼ to change pressure unit. Press key
START/STOP to confirm and to finish the operation mode.
hPa