Installing An Intrusion Switch - Dell EMC PowerEdge R940 Installation And Service Manual

Installing an intrusion switch

Prerequisites
Follow the safety guidelines listed in
Steps
1 Slide the intrusion switch into the intrusion switch slot.
2 Route the cables through the cable routing hooks on the side of the system.
3 Lower the cable management bracket into the system.
4 Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
5 Connect the cable to the connector (INTRUSION) on the system board.
Figure 32. Installing an intrusion switch
Next steps
1 Lift the sides of the fan tray until the blue release tabs click in place.
2 If applicable, install the PEM.
3 If applicable, install the expansion card risers.
4 Install the air shroud.
5 Install the fan cage.
6 Follow the procedure listed in
Safety instructions.
After working inside your system.
Installing and removing system components 79