Removing The Processor From The Processor And Heat Sink Module - Dell EMC PowerEdge R940 Installation And Service Manual

3 Remove the air shroud.
4 If installed, remove the expansion card risers and lift the PEM to the upright position.
Steps
1 Using a Torx #T30 screwdriver, loosen the screws on the heat sink.
NOTE: Ensure that you loosen one screw before moving on to the next screw.
2 Pushing both retention clips simultaneously, lift the processor and heat sink module (PHM) out of the system.
3 Set the PHM aside with the processor side facing up.
Figure 55. Removing the processor and heat sink module
Next steps
1 Install the PHM.
Related links
Removing the expansion card riser
Installing a processor and heat sink module
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the processor and heat sink module.
102 Installing and removing system components
Safety instructions.
Before working inside your system.