Removing The Fan Tray - Dell EMC PowerEdge R940 Installation And Service Manual

Figure 28. Installing the fan cage
Next steps
1 Follow the procedure listed in

Removing the fan tray

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the fan cage.
5 If installed, remove the expansion card risers.
6 If applicable, lift the PEM by using the PEM handle until the PEM is in an upright position.
7 Release the backplane and fan power cables from the cable clips on the fan tray and disconnect the power cables from the
connectors on the system board.
Steps
1 Press the blue release tabs on the side of the fan tray to unlock the tray.
2 Holding the fan tray lift the tray out of the system.
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 75