Dell EMC PowerEdge R940 Installation And Service Manual page 12

System health and system ID indicator code
Solid amber
Blinking amber
iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is located on the left control panel of your system.
Figure 5. iDRAC Quick Sync 2 indicators
Table 6. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator
code
Off (default state)
Solid white
Blinks white rapidly
Blinks white slowly
Blinks white five times rapidly and
then turns off
Solid amber
Blinking amber
12 PowerEdge R940 overview
Condition
Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC Quick
Sync 2 button to turn on the iDRAC Quick
Sync 2 feature.
Indicates that iDRAC Quick Sync 2 is ready
to communicate. Press the iDRAC Quick
Sync 2 button to turn off.
Indicates data transfer activity.
Indicates that firmware update is in
progress.
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Indicates that the system is in fail-safe
mode.
Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Condition
Indicates that the system is in fail-safe mode. If the problem persists,
see the Getting help section.
Indicates that the system is experiencing a fault. Check the System
Event Log or the LCD panel, if available on the bezel, for specific error
message. For more information about error messages, see the Dell
Event and Error Messages Reference Guide at Dell.com/
openmanagemanuals > OpenManage software.
Corrective action
If the LED fails to turn on, reseat the left control panel
flex cable and check again. If the problem persists,
see the Getting help section.
If the LED fails to turn off, restart the system. If the
problem persists, see the Getting help section.
If the indicator continues to blink indefinitely, see the
Getting help section.
If the indicator continues to blink indefinitely, see the
Getting help section.
Check if iDRAC Quick Sync 2 feature is configured to
be disabled by iDRAC. If the problem persists, see the
Getting help section. For more information, see
Integrated Dell Remote Access Controller User's
Guide at Dell.com/idracmanuals or Dell
OpenManage Server Administrator User's Guide at
Dell.com/openmanagemanuals.
Restart the system. If the problem persists, see the
Getting help section.
Restart the system. If the problem persists, see the
Getting help section.