Installing The Ndc; Storage Controller Card - Dell EMC PowerEdge R940 Installation And Service Manual

Installing the NDC

Prerequisites
Follow the safety guidelines listed in
Steps
1 Orient the NDC so that the Ethernet ports fit through the slot in the NDC riser.
2 Align the captive screws on the card with the screw holes on the NDC riser.
3 Press the touch points on the card until the card connector engages with the connector on the NDC riser.
4 Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the NDC riser.
Figure 81. Installing the NDC
Next steps
1 Install the NDC riser.
2 Follow the procedure listed in
Related links
Installing the NDC riser

Storage controller card

The storage controller card is installed on the expansion card slot on the system board, which provides the integrated storage subsystem
for your system's internal hard drives. The controller supports SAS and SATA hard drives and also enables you to set up the hard drives in
RAID configurations as supported by the version of the storage controller included with your system.
128 Installing and removing system components
Safety instructions.
After working inside your system.