Removing The Storage Controller Card - Dell EMC PowerEdge R940 Installation And Service Manual

Removing the storage controller card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the Network Daughter Card (NDC) riser.
Steps
1 Slide the riser retention bracket to unlock the storage controller card.
2 Hold the storage controller card by its edges and lift to remove it from the connector on the system board.
3 Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
Figure 82. Removing the storage controller card
Next steps
1 Install the storage controller card.
Related links
Removing the NDC riser
Installing the storage controller card
Safety instructions.
Before working inside your system.
Installing and removing system components 129