Advertisement
Attaching front brackets to switch
Complete the following steps to attach the front brackets to the switch.
1. Position the right front bracket (Item 1) with the flat side against the right side of the switch
2. Insert two 8-32 x 5/16 in. screws (Item 3) into one of the pairs of vertically aligned holes in the bracket and then
into the pair of holes on the side of the switch. To install the switch in a recessed position in the cabinet, use the
bracket holes that are set back from the end of the bracket.
3. Insert each 8-32 x 5/16 in. screw (Item 3) through the holes in the bracket and into the corresponding hole in
the switch.
4. Tighten all 8-32 x 5/16 in. screws to a torque of 15 in.-lbs (17 cm-kgs).
5. Repeat
step 1
through
1
Bracket, front right
FIGURE 2
Attaching the front bracket
Attaching front rails to a cabinet
Complete the following steps to install the switch in the cabinet.
1. Position the switch in the cabinet
secured to the cabinet.
2. Attach the right front bracket (Item 1) to the right front rack rail using three 10-32 x 5/8 in. screws (Item 5) and
three retainer nuts (Item 6).
3. Repeat
step 2
to attach the left front bracket (Item 2) to the left front rack rail.
4. Tighten all 10-32 x 5/8 in. screws (Item 5) to a torque of 25 in.-lbs (29 cm-kgs).
6
step 4
to attach the left front bracket (Item 2) to the left side of the switch.
3
Screw, 8-32 x 5/16 in., panhead Phillips
(Figure
3), providing temporary support under the switch until the rail kit is
(Figure
Mid-Mount Rack Kit (Switch) Installation Procedure
2).
53-1001791-01
Advertisement
