Removing The Doors From The Rack - Dell PowerVault 130T Installation Manual

Installing the PowerVault 130T Kit
Use the following procedure to install the PowerVault 130T system rack kit in the rack:
1. Remove the doors from the rack.
2. Install the adjustable mounting rails in the rack.
NOTE: If you purchased a Dell rack along with your PowerVault 130T system, the
mounting rails are preinstalled in the rack.
3. Install the cage nuts in the rack.
4. Install the PowerVault 130T system.
5. Replace the doors.
The subsections that follow include instructions for performing these tasks.

Removing the Doors From the Rack

You must remove the front and back doors from the rack to provide access to the inte-
rior of the rack and to prevent damage to the doors while installing the kit. Use the
following procedure to remove the doors.
WARNING: To prevent personal injury due to the size and weight of the
doors, never attempt to remove the doors by yourself.
1. Open the latch on the front door (see Figure 1-2).
Slide the latch's push button cover up as far as it will go, press the push button,
rotate the handle clockwise until the latch releases, and then pull the door open.
Dell PowerVault 130T Storage System Rack Kit Installation Guide 1-3