Connect the power supply
Pay attention to the local wiring regulations that need
to be followed when connecting to mains supply.
Look upward from inside the caravan, and locate the
terminal block as shown in the figure below.
Connect the external power lines to the 3-pole terminal
block and note the positions of the active, neutral and
ground.
Match the corresponding active (brown),
neutral (blue) and the ground wire (yellow
green) and firmly tighten up the screws to
make sure the power line is not loose or
improperly connected, otherwise a short
circuit or fire could be caused.
Installation of M8 bolts
Note
3 Pole terminal block
Connect M8 bolts, washers and fixing metal plates in
order as the following figure.
Lift the plenum mounting bracket toward the machine.
Insert M8 blots, washers and fixing plates to the holes
of the 4 corners. Start the bolts off using finger effort.
Ensure all bolts have started correctly for at least 2 or 3
rotations to avoid cross threading.
Ensure the metal fixing plates align with the
corresponding recess in the plenum mounting bracket
as the bolts are tightened.
Evenly tighten up all four bolts .
Connection of outlet air duct
11