The right lower figure shows the minimum distance of the installation position of the panel, measure in reference to 400x
400mm holes.
Installation of chassis reinforced
support
Make sure the roof is clean and dry and free from oil & grease.
Confirm orientation by starting with the "this side up" logo upwards.
Turn the part over and on the reverse side of "this side up", apply silicone sealant uniformly over the path shown.
Turn the part over again and make sure "this side up" is up. Press down firmly over the 400×400mm hole and remove
any sealant that has squeezed out to form an effective seal.
This side up
This side up
400x400
Sealant path
9