Lucent Technologies Metropolis Installation Manual page 201

Fiber Management Installation (Optional)
...........................................................................................................................................................................................................................................................
365-372-304
Issue 7, March 2003
............................................................................................................................................................................
Position one of the brackets along the left side of shelf 1. Secure with 3
Step 8
bracket mounting screws.
............................................................................................................................................................................
Repeat Step 8 for all the other shelves being installed.
Step 9
............................................................................................................................................................................
Step 10 Locate three spools (848919221), one fiber radius control module (321-
1B), one right fiber spool bracket (848919221) and 3 M4 X 6 bracket
mounting screws (901340059) for each shelf being installed.
............................................................................................................................................................................
For each spool, put a nylach fastener through the middle. Then insert a
Step 11
pin halfway though.
Important!
inserted. This will deform the fastener and prevent it from being
assembled to the bracket.
............................................................................................................................................................................
Step 12 Line up the nylach fastener in one of the spools with the large holes on
the top arm of the bracket.
............................................................................................................................................................................
Spin the spool until the peg on its back fits into the smaller hole on the
Step 13
arm of the bracket. This will keep the spool from spinning any further.
............................................................................................................................................................................
Step 14 Push the pin until it is completely fastened.
............................................................................................................................................................................
Repeat Step 12 through Step 14 for all the spools, with three per
Step 15
bracket.
............................................................................................................................................................................
Step 16 Attach one fiber radius control module to the bottom of each bracket.
............................................................................................................................................................................
Position one of the brackets along the right side of shelf 1. Secure with
Step 17
3 bracket mounting screws.
Lucent Technologies - Proprietary
See notice on first page
Equipment and Cable Installation for DMX High Capacity
It is very important that the pin is not completely
Shelf
3 - 2 9