Saunatec Patio 4 x 6 Owner's Manual page 4

INSTALLATION OF SAUNA ROOM
1. Place the floor panel in the desired location on a level surface (Note: The floor panel must be level
before installing wall and ceiling panels. If the surface is not level you may need to shim the bottom
panel to get it level.)
The base is numbered to cooraspond with the panels for correct locations. The right wall is labeled # 1,
the back right panel is labeled #2 and etc...(See picture below)
2. Place the right wall panel on the outer edge of the floor panel.
3. Place the right back
corner panel pins
into right wall slots.
4. Place and latch the left side back wall panel to right back wall panel.
710-0131
Rev. 02
Page 4 of 16 05/05/15