Setting A Password - Canon ScanFront 400 Instructions Manual

• Adjust the wait time until the display automatically
turns off.
Set the ScanFront to turn off the touch panel display after
a specified period of inactivity.
IMPORTANT
After the display off function turns off the panel display, you
can restore the display by touching the panel.
• Adjust the wait time until the Low Power Mode.
Set the scanner to switch to Low Power mode after a
specified period of inactivity.
IMPORTANT
• When the scanner switches to Low Power mode, the touch
panel display turns off and the power button flashes. To
switch out of Low Power mode, press the power button.
• Note that if the scanner transitions to Low Power mode when
the placed documents run out after scanning is started, or
scanning is suspended because of a paper jam or double
feed, all the images that were scanned prior to the
suspending of scanning and that were not yet transmitted
are discarded.
• You will not be able to operate the scanner immediately after
power is restored from Low Power mode. Operation will be
enabled after about 15 seconds, so please wait a moment
before attempting operation.
• Allow remote operation.
Set this to [ON] to allow access to the ScanFront from an
external terminal via a web browser or ScanFront
Administration Tool for SF400. (See p. 154.)
152
Chapter 5 Administrator Settings
• Reduction ratio adjustment (%)
When the feed roller is worn, scanned images may
appear stretched in the vertical direction. In such cases,
using the [Reduction ratio adjustment] function may
reduce the stretching. The specifiable range for the
adjustment value is -3.0% to 3.0%.
❏ Setting a Password
Set the password for restricting the display of the
ScanFront maintenance screen.
If you set a password, password confirmation is performed
when displaying the ScanFront maintenance screen.
Hint
The password field is empty under default conditions.