Canon ScanFront 400 Instructions Manual page 194

There is no file name specified.
Enter a file name or enable the
'Auto file name' setting.
Failed to send the files.
You can't use following
character for File name.
Can not create folder.
A character that cannot be used
for a host name is included.
You can't choose JPEG when
Binary Mode is selected.
You can't choose Text enhance
when Bleed-through reduction is
selected.
Cause
A file name was not entered and "Auto file name" is set to [None].
Enter a file name or set "Auto file name" to other than [None].
Solution
p. 98.)
The destination is incorrect, or connection to the destination cannot be
Cause
established.
Check whether the host name, FTP server, email address, or folder path
Solution registered as the destination is correct, and check whether connection to
the destination is possible.
Cause Invalid characters have been used to set the custom file name.
Make sure the custom file name does not contain any of the following
Solution characters:
/ : ? * " < > |
Cause The USB memory device is not connected properly.
Solution Check the connection of the USB memory device.
Cause
An invalid character exists in the specified host name.
Do not use the following characters when the specifying host names.
Solution
/:?*"<>|
The scanner cannot be used with the selected mode and file format
Cause
combination.
Check which mode and file format combinations can be used.
Solution
p. 87.)
The scanner cannot be used with the selected mode and setting
Cause
combination.
Solution Check which mode and setting combinations can be used.
194
Chapter 9 Troubleshooting
(See
(See
(See p. 87.)