Placing A Carrier Sheet - Canon ScanFront 400 Instructions Manual

CAUTION
• Place the cards one at a time.
• When scanning cards, place them to be fed horizontally. If you
place cards to be fed vertically, they may not be ejected
properly, and cards that get jammed may be damaged when
you remove them.
• When scanning cards, set [Double feed detection by
Ultrasonic] to [OFF] in the Detailed Settings screen.
p. 89.)
• Pull the lock lever and open the panel unit before removing a
placed card. Inserting a finger into the scanner while the panel
unit is closed may result in an injury.
Hint
When scanning cards without embossing, up to 10 cards can be
placed on the scanner at the same time. In such cases, set
[Document type] to [Extra-thick paper/plastic card] in the
Detailed Settings screen. (See p. 94.)
(See
Lock lever
49
❏ Placing a Carrier Sheet
When scanning a document that requires extra protection
from damage, insert the document into an optional carrier
sheet before placing it in the scanner.
1.
Set [Document type] to [Carrier sheet] in the Detailed
Settings screen. (See p. 94.)
2.
Insert the document into the carrier sheet.
3.
Load the document with the page you want to scan
facing down.
After placing the document, align the document guides
with both edges of the document.
CAUTION
• If the carrier sheet or passport is not loaded properly, you may
get a document jam or not get a scan image as intended
• When [Carrier sheet] is selected, [Double feed detection by
Ultrasonic] will be set to [OFF] automatically.
IMPORTANT
• Insert documents straight into the center of the carrier sheet.
Proper scanning will not be possible if the document is too
close to either side, tilted, or protruding from the carrier sheet.
Chapter 3 Handling