HP 5120 SI Series Security Configuration Manual page 336

# Assign ports GigabitEthernet 1/0/1 to GigabitEthernet 1/0/3 to VLAN 10.
[SwitchB] interface gigabitethernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] port access vlan 10
[SwitchB-GigabitEthernet1/0/1] quit
[SwitchB] interface gigabitethernet 1/0/2
[SwitchB-GigabitEthernet1/0/2] port access vlan 10
[SwitchB-GigabitEthernet1/0/2] quit
[SwitchB] interface gigabitethernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] port link-type trunk
[SwitchB-GigabitEthernet1/0/3] port trunk permit vlan 10
[SwitchB-GigabitEthernet1/0/3] quit
# Enable ND snooping in VLAN 10.
[SwitchB] vlan 10
[SwitchB-vlan 10] ipv6 nd snooping enable
# Enable ND detection in VLAN 10.
[SwitchB-vlan 10] ipv6 nd detection enable
[SwitchB-vlan 10] quit
# Configure the uplink port GigabitEthernet 1/0/3 as an ND-trusted port, and the downlink ports
GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 as ND-untrusted ports (the default).
[SwitchB] interface gigabitethernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] ipv6 nd detection trust
The configuration enables Switch B to check all incoming ND packets of ports GigabitEthernet 1/0/1
and GigabitEthernet 1/0/2 based on the ND snooping table.
324