HP 5120 SI Series Security Configuration Manual page 163

Figure 58 Device list
On the port group configuration page, click Add to enter the page shown in
following configurations:
Enter the port group name.
•
Select the configured IP address group. The IP address used by the user to access the network must
•
be within this IP address group.
Use the default settings for other parameters.
•
Figure 59 Add a port group
# Select Service Parameters > Validate System Configuration from the navigation tree to validate the
configurations.
Configure the portal server (iMC PLAT 5.0)
2.
NOTE:
This example assumes that the portal server runs on iMC PLAT 5.0(E0101) and iMC UAM 5.0(E0101).
# Configure the portal server.
Log in to the iMC management platform and select the Service tab. Then, select User Access Manager >
Portal Service Management > Server from the navigation tree to enter the portal server configuration
page, as shown in Figure
• Configure the portal server heartbeat interval and user heartbeat interval.
Use default values for other parameters.
•
65.
151
Figure 64. Perform the