HP 5120 SI Series Security Configuration Manual page 152

Select User Access Manager > Portal Service Management > Device from the navigation tree to enter the
portal device configuration page. Then, click Add to enter the page shown in
Enter the device name NAS.
•
Enter the IP address of the switch's interface connected to the user.
•
Enter the key, which must be the same as that configured on the switch.
•
• Set whether to enable IP address reallocation. This example uses direct portal authentication, and
therefore select No from the Reallocate IP list.
Select whether to support sever heartbeat and user heartbeat functions. In this example, select No
•
for both Support Server Heartbeat and Support User Heartbeat.
Figure 48 Add a portal device
# Associate the portal device with the IP address group.
As shown in Figure 54, click the icon in the Port Group Information Management column of device NAS
to enter the port group configuration page.
Figure 49 Device list
On the port group configuration page, click Add to enter the page shown in
following configurations:
Enter the port group name.
•
Select the configured IP address group. The IP address used by the user to access the network must
•
be within this IP address group.
• Use the default settings for other parameters.
140
Figure 53.
Figure 55. Perform the