HP 5120 SI Series Security Configuration Manual page 97

Figure 27 Network diagram for 802.1X with guest VLAN and VLAN assignment configuration
Configuration procedure
NOTE:
The following configuration procedure covers most AAA/RADIUS configuration commands on the device.
The configuration on the 802.1X client and RADIUS server are omitted. For more information about
AAA/RADIUS configuration commands, see the
1. Configure the 802.1X client. Make sure the client is able to update its IP address after the access
port is assigned to the guest VLAN or a server-assigned VLAN. (configuration omitted)
2. Configure the RADIUS server to provide authentication, authorization, and accounting services.
Configure user accounts and server-assigned VLAN, VLAN 5 in this example. (configuration
omitted)
3. Create VLANs, and assign ports to the VLANs.
<Device> system-view
[Device] vlan 1
[Device-vlan1] port gigabitethernet 1/0/2
[Device-vlan1] quit
[Device] vlan 10
[Device-vlan10] port gigabitethernet 1/0/1
[Device-vlan10] quit
[Device] vlan 2
[Device-vlan2] port gigabitethernet 1/0/4
[Device-vlan2] quit
[Device] vlan 5
Security Command Reference
85
.