Configuring The Device As An Stelnet Client; Stelnet Client Configuration Task List - HP VSR1000 Security Configuration Manual

To set the SSH management parameters:
Step
1. Enter system view.
2. Enable the SSH server to
support SSH1 clients.
3. Set the RSA server key pair
update interval.
4. Set the SSH user
authentication timeout period.
5. Set the maximum number of
SSH authentication attempts.
6. Configure an ACL filtering for
IPv4 SSH clients.
7. Configure an ACL filtering for
IPv6 SSH clients.
8. Set the DSCP value in the IPv4
packets that the SSH server
sends to the SSH clients.
9. Set the DSCP value in the IPv6
packets that the SSH server
sends to the SSH clients.
10. Configure the SFTP
connection idle timeout
period.
11. Specify the maximum number
of concurrent online SSH
users.

Configuring the device as an Stelnet client

Stelnet client configuration task list

Tasks at a glance
(Optional.)
(Required.)
Specifying a source IP address for SSH packets
Establishing a connection to an Stelnet server
Command
system-view
ssh server compatible-ssh1x
enable
ssh server rekey-interval hours
ssh server authentication-timeout
time-out-value
ssh server authentication-retries
times
ssh server acl acl-number
ssh server ipv6 acl [ ipv6 ]
acl-number
ssh server dscp dscp-value
ssh server ipv6 dscp dscp-value
sftp server idle-timeout
time-out-value
aaa session-limit ssh max-sessions
253
Remarks
N/A
By default, the SSH server supports
SSH1 clients.
This command is not available in
FIPS mode.
By default, the RSA server key pair
is not updated.
This command is not available in
FIPS mode.
The default setting is 60 seconds.
The default setting is 3.
By default, all IPv4 SSH users are
allowed to initiate connections with
the SSH server.
By default, all IPv6 SSH users are
allowed to initiate connections with
the SSH server.
The default setting is 48.
The default setting is 48.
The default setting is 10 minutes.
The default setting is 16.
Changing the upper limit does not
affect online SSH users.