HP VSR1000 Security Configuration Manual page 105

[Router-isp-dm1] quit
# Configure domain dm1 as the default ISP domain. If a user enters the username without the ISP
domain name at login, the authentication and accounting methods of the default domain are used
for the user.
[Router] domain default enable dm1
3. Configure ACL 3000 for resources on subnet 192.168.0.0/24 and ACL 3001 for Internet
resources:
[Router] acl number 3000
[Router-acl-adv-3000] rule permit ip destination 192.168.0.0 0.0.0.255
[Router-acl-adv-3000] rule deny ip
[Router-acl-adv-3000] quit
[Router] acl number 3001
[Router-acl-adv-3001] rule permit ip
[Router-acl-adv-3001] quit
NOTE:
Make sure you specify ACL 3000 as the isolation ACL and ACL 3001 as the security ACL on the
security policy server.
4. Configure portal authentication:
# Configure a portal authentication server.
[Router] portal server newpt
[Router-portal-server-newpt] ip 192.168.0.111 key simple portal
[Router-portal-server-newpt] port 50100
[Router-portal-server-newpt] quit
# Configure a portal Web server.
[Router] portal web-server newpt
[Router-portal-websvr-newpt] url http://192.168.0.111:8080/portal
[Router-portal-websvr-newpt] quit
# Enable direct portal authentication on interface GigabitEthernet 2/0.
[Router] interface gigabitethernet 2/0
[Router–GigabitEthernet2/0] portal enable method direct
# Reference the portal Web server newpt on interface GigabitEthernet 2/0.
[Router–GigabitEthernet2/0] portal apply web-server newpt
# Configure the BAS-IP as 2.2.2.1 for portal packets sent from GigabitEthernet 2/0 to the portal
authentication server.
[Router–GigabitEthernet2/0] portal bas-ip 2.2.2.1
[Router–GigabitEthernet2/0] quit
Verifying the configuration
# Verify that the portal configuration has taken effect.
[Router] display portal interface gigabitethernet 2/0
Portal information of GigabitEthernet 2/0
IPv4:
Portal status: Enabled
Authentication type: Direct
Portal Web server: newpt
95