HP VSR1000 Security Configuration Manual page 109

[Router] interface gigabitethernet 2/0
[Router–GigabitEthernet2/0] ip address 20.20.20.1 255.255.255.0
[Router–GigabitEthernet2/0] ip address 10.0.0.1 255.255.255.0 sub
[Router-GigabitEthernet2/0] dhcp select relay
[Router-GigabitEthernet2/0] dhcp relay server-address 192.168.0.112
# Enable authorized ARP.
[Router-GigabitEthernet2/0] arp authorized enable
[Router-GigabitEthernet2/0] quit
5. Configure portal authentication:
# Configure a portal authentication server.
[Router] portal server newpt
[Router-portal-server-newpt] ip 192.168.0.111 key simple portal
[Router-portal-server-newpt] port 50100
[Router-portal-server-newpt] quit
# Configure a portal Web server.
[Router] portal web-server newpt
[Router-portal-websvr-newpt] url http://192.168.0.111:8080/portal
[Router-portal-websvr-newpt] quit
# Enable re-DHCP portal authentication on interface GigabitEthernet 2/0.
[Router] interface gigabitethernet 2/0
[Router-GigabitEthernet2/0] portal enable method redhcp
# Reference the portal Web server newpt on interface GigabitEthernet 2/0.
[Router–GigabitEthernet2/0] portal apply web-server newpt
# Configure the BAS-IP as 20.20.20.1 for portal packets sent from GigabitEthernet 2/0 to the
portal authentication server.
[Router–GigabitEthernet2/0] portal bas-ip 20.20.20.1
[Router–GigabitEthernet2/0] quit
Verifying the configuration
# Verify that the portal configuration has taken effect.
[Router] display portal interface gigabitethernet 2/0
Portal information of GigabitEthernet 2/0
IPv4:
Portal status: Enabled
Authentication type: Redhcp
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Not configured
Server name
--
Mask
Mask
99
Action
--