Ipsec Sa Negotiation Failed Because No Matching Ipsec Transform Sets Were Found - HP VSR1000 Security Configuration Manual

------------------------------------------------------------------
1
Flags:
RD--READY RL--REPLACED FD-FADING
2. The following IKE event debugging or packet debugging message appeared:
IKE event debugging message:
Notification PAYLOAD_MALFORMED is received.
IKE packet debugging message:
Construct notification packet: PAYLOAD_MALFORMED.
Analysis
If the following debugging information appeared, the matched IKE profile is not referencing the
•
matched IKE proposal:
Failed to find proposal 1 in profile profile1.
If the following debugging information appeared, the matched IKE profile is not referencing the
•
matched IKE keychain:
Failed to find keychain keychain1 in profile profile1.
Solution
Verify that the matched IKE proposal (IKE proposal 1 in this debugging message example) is
•
referenced by the IKE profile (IKE profile 1 in the example).
Verify that the matched IKE keychain (IKE keychain 1 in this debugging message example) is
•
referenced by the IKE profile (IKE profile 1 in the example).
IPsec SA negotiation failed because no matching IPsec
transform sets were found
Symptom
1. The display ike sa command shows that the IKE SA negotiation succeeded and the IKE SA is in RD
state, but the display ipsec sa command shows that the expected IPsec SA has not been negotiated
yet.
2. The following IKE debugging message appeared:
The attributes are unacceptable.
Or:
Construct notification packet: NO_PROPOSAL_CHOSEN.
Analysis
Certain IPsec policy settings are incorrect.
Solution
1. Examine the IPsec configuration to see whether the two ends have matching IPsec transform sets.
2. Modify the IPsec configuration to make sure the two ends have matching IPsec transform sets.
192.168.222.5
241
Unknown IPSEC