Table of Contents
Advertisement
PILOT 300
PR-2301
This product manual contains important information about the safe installation and
use of this projector. Please read and follow these instructions carefully and keep this
manual in a safe place for future reference.
PR LIGHTING LTD
571 Yingbin Road Dashi Panyu Guangzhou 511430, China
http://www.pr-lighting.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PR Lighting PILOT 300
Summary of Contents for PR Lighting PILOT 300
- Page 1 PILOT 300 PR-2301 This product manual contains important information about the safe installation and use of this projector. Please read and follow these instructions carefully and keep this manual in a safe place for future reference. PR LIGHTING LTD 571 Yingbin Road Dashi Panyu Guangzhou 511430, China...
-
Page 2: Table Of Contents
Please read and follow these instructions carefully and keep this manual in a safe place for future reference. The PILOT 300 is an innovative projector with an elegant housing, which is made from high intensity and heat–resistant complex plastic. PILOT 300 complies to CE norms and standards and uses international protocol DMX 512. -
Page 3: Safe Usage Of The Projector
Always disconnect from the mains, when the device is not in use or before cleaning it or before attempting any maintenance work. If you have any questions, don’t hesitate to consult your dealer or manufacturer. 3/14 pilot 300 manual.doc... -
Page 4: Installing The Projector
Always ensure that the structure to which you are attaching the projector is secure and is able to support a weight of 18Kg for each PILOT 300. For safety the projector should have a secondary fixing with a safety chain through the holes on the underside of the unit. -
Page 5: Power Supply – Mains
Press the key ENTER to save the selected function and configuration. If the display is showing “y”, then the setting has been enabled. In the same way, if it was showing “n” when you pressed ENTER the option has been disabled. The Red LED will flash during this operation. 5/14 pilot 300 manual.doc... -
Page 6: Stand-Alone Mode
Note, care should be taken to ensure that none of the connections touch the body of the plug or each other. The body of the plug is not connected in any way. The PILOT 300 accepts digital control signals in standard DMX512 (1990) format. -
Page 7: Master/Slave Mode
DMX terminator as shown in the figure below. CONTROLLER MODE - DMX OPERATION Each PILOT 300 must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start address is the channel number from which the projector starts to “listen”... -
Page 8: Dmx Control Channel Functions
DMX CONTROL CHANNEL FUNCTIONS The PILOT 300 uses 10 DMX channels. They are listed in the following table. CHANNEL DMX VALUE DESCRIPTION Open/Clear 0-33 5-7: After 3 seconds, the projector will reset and then restart 34-66 Gobo 1 67-99 Gobo 2... -
Page 9: Change The Gobos
Do not over lubricate as this will cause spillage when the wheel rotates. 9/14 pilot 300 manual.doc... -
Page 10: Keeping The Projector Clean
The beam appears dim -Dust or grease contamination Check the optics are clean. on the optics. -The lamp is at the end of its Replace with a new lamp of the life specified type and rating. 10/14 pilot 300 manual.doc... -
Page 11: Technical Data
DMX512: 8 Channels plus 2 for Hi Res. Pan and Tilt Stand-Alone Automatic mode MOTORS: 10 Stepper motors HOUSING: Metal and composite plastic (IP20) DIMENSIONS: See drawings below. WEIGHT: 18Kg. PACKED DIMENSIONS: 450mm LONG x 450mm WIDE x 610mm HIGH PACKED WEIGHT: 20Kg. 11/14 pilot 300 manual.doc... -
Page 12: Electrical Diagram
LIGHT OUTPUT ELECTRICAL DIAGRAM 12/14 pilot 300 manual.doc... - Page 13 290151218 HTD420-3M-140Z TEETH NOTE: You may order all parts of the PILOT 300 besides the table listed above. When ordering please state the exact name and part no.. Repairs must be carried out by a qualified technician. 13/14 pilot 300 manual.doc...
- Page 14 PR LIGHTING LTD 571 Yingbin Road Dashi Panyu Guangzhou 511430, China TEL: +86 (20) 8478 1888 FAX: +86 (20) 8478 6023 P/N: 321010041 Last Revision: 14:09:2002 14/14 pilot 300 manual.doc...
Need help?
Do you have a question about the PILOT 300 and is the answer not in the manual?
Questions and answers