Allen-Bradley 1756-L61 User Manual page 66

Chapter 3 Start Using the Controller
66
If Load/Store is dimmed (unavailable), verify the following:
TIP
• You have specified the correct communication path and are online with the
controller in Program mode.
• The memory card is installed.
• With the 1756-L7x controllers, if the SD card is locked, Store is dimmed
(unavailable) and the locked status is indicated in the bottom-left corner of
the Nonvolatile memory/Load Store dialog box. See
If the memory card is not installed, a message in the lower-left corner of the
Nonvolatile Memory tab indicates the missing card as shown here.
3. Change the Load Image, Load Mode, and Automatic Firmware Update
properties according to your application requirements.
The following table describes the Load Image options that you can choose
for the project.
IMPORTANT
If you want the image (project) to load when
Power to the controller is applied or cycled
The controller has lost the project and power has been cycled or
applied
Initiated via the Logix Designer application
The following table describes the Load Mode options that you can choose
for the project.
If you want the controller to go to this mode after
loading
Program
Run
Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
If the SD card is locked and the Load Image option of the project is set
to On Power Up, the controller firmware is not updated as a result of a
firmware upgrade. The previously stored firmware and project are
loaded instead.
step 4.
Then choose
On Power Up
On Corrupt Memory
User Initiated
Then choose
Program (remote only)
Run (remote only)