ABB ACH550-01 User Manual page 154

ACH550-01 User's Manual
Note: Correct installation of the screws is essential for fulfilling
the EMC requirements and for proper operation of the module.
Note: Install the input power and motor cables first.
Setting up communication through a plug-in fieldbus
adapter (EXT FBA) module
Before configuring the drive for fieldbus control, the fieldbus
adapter (EXT FBA) module must be mechanically and
electrically installed according to the instructions given in this
manual and the fieldbus adapter module manual.
The communication between the drive and the fieldbus adapter
module is then activated by setting parameter 9802
to
SEL EXT FBA
configuration parameters of the module become available in
parameter Group 51: EXT COMM MODULE
Setting up FBA with the Serial Communication assistant is
shown below. The related parameters are described starting
from page 150.
Setting up FBA with the Serial Communication assistant
To set up FBA, follow these steps:
1 Press MENU to go to the
main menu.
2 Select ASSISTANTS with
the UP/DOWN keys and
press ENTER.
3 Scroll to Serial
Communication and press
SEL.
Serial communications
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
. After the communication is initialized, the
COMM PROT
in the drive.
OFF
0. 0 Hz
0. 0 A
0. 0 %
00:00 MENU
OFF MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT 00:00 ENTER
OFF ASSISTANTS
Low Noise Set-up
Panel Display
Timed Functions
Outputs
Serial Communication
EXIT 00:00
0.0Hz
2
14
SEL
149