Phones - T+A E-SERIES PA 1000 E User Manual

Phones

Headphones

 
Socket for stereo headphones with a minimum impedance of 32 .

Note regarding the use of headphones

Continuous listening to programme material at very high volume using
headphones or earphones can result in permanent loss of hearing. You can
avoid subsequent health problems by avoiding continuous listening at high
volume through headphones or earphones.
Button for switching ON and OFF the loudspaker output.
This button can be used to switch the loudspeakers OFF when listening with
headphones.
The LED above the button will glow when the loudspeaker output is switched
OFF.

The speaker LED will blink for some seconds during the switch ON delay after
powering the device ON.
If the speaker LED is blinking constantly for a longer time this indicates that the
protection circuit of the PA 1000 E has turned OFF the speaker outputs to
prevent damages to the device or to your loudspeakers.
Causes for the tripping of the protection circuit can be overheat, short circuit at
the speaker output or overload of the amplifier. For further information please
see also chapter 'Trouble Shooting'.
27