Command Line Mode - Planet GS-4210-16T2S User Manual

6. Command Line Mode

The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
The following screen based on GS-4210-24P2S will be t he same as that of GS-4210-16T2S, GS-4210-24T2S,
GS-4210-48T4S and GS-4210-16P2S.
Mode-based Command Hierarchy
The Command Line Interface (CLI) groups all the commands in appropriate modes by the nature of the commands. Examples
of the CLI command modes are described below. Each of the command modes supports specific switch's commands.
The CLI Command Modes table captures the command modes, the prompts visible in that mode and the exit method from that
mode.
Command Mode
User Mode
Privileged Mode
Global Config Mode
The CLI is divided into various modes. The commands in one mode are not available until the operator switches to that
particular mode. The commands available to the operator at any point in time depend upon the mode. Entering a question mark
(?) at the CLI prompt, and displayss a list of the available commands and descriptions of the commands.
User's Manual of GS-4210-16T2S_24T2S_16P2S_24P2S_48T4S
Access Method
This is the first level of access.
Perform basic tasks and list
system information.
From the User Mode, enter the
enable command.
From the Privileged Mode,
enter the configuration
command.
Table 6-1: CLI Command Modes
Prompt
GS-4210-24P2S>
GS-4210-24P2S #
GS-4210-24P2S
(Config)#
395
Exit or Access Previous
Mode
Enter exit command
To exit to the User Mode, enter
exit .
To exit to the Privileged Mode,
enter the exit command.