Assign A Function Key To Each Mode; Configuration Sheet: Telephone Ring Assignment - NEC SL2100 Getting Started Manual

2.6.5 Assign a Function Key to each mode

To assign a key to each mode, you need to exit the Programming Mode. The keys are set using the telephone,
not within SL2100 Programming Mode.
Assign keys at the telephone(s) that will change the mode. A phone with an LCD is preferable.
This is not done within the SL2100 Configuration Mode. Keys are changed by dialing a service code using
telephone itself.
You will need a separate key for each mode you are using.
The key for the current mode lights red. To change the mode, press the appropriate key.
2.6.5.1 Default Setting
There are no keys set to day/night modes on any of the telephones.
No. Operation
1 At the telephone that you want to be able to change day/night mode,
press Speaker key.
2 Dial service code 751.
3 Press the Programmable Function Key you want to set (its current
setting is shown in LCD display). If the key is not defined the function,
go to step 5.
4 If the Function Key is already assigned the function but not used, press
Speaker Key + 752 + Function Key (to be cleared) + 000 + Speaker
key to clear the current setting and go back to step 1 again to set the
Function Key.
5 Dial 09 followed by the mode number 1 to 8.
1 = Day
2 = Night 1
3 = Mid-Night 1
4 = Rest 1
5 = Day 2
6 = Night 2
7 = Mid-Night 2
8 = Rest 2
☞ If you want to clear the Day/Night Mode key, press 00 after Step 3 to
clear the function.
6 Repeat 3 and 4 to set additional keys/modes.

2.6.6 Configuration sheet: Telephone Ring Assignment

Defaults are shown.
Place the telephones into Ring Groups.
IRG
Number
IRG 1
Default=101-108
IRG 2
IRG 3
SL2100 GETTING STARTED GUIDE
List of telephones that will ring
PRG 22-04-01
Display Shows;
____1-20_FRI__ 6:51PM____
101______________DONALD
_Menu__Dir__VM:00_CL:00_
Key Program
Key Program_______Key xx
xxxxxxxxxxxxxxx
__
Key Program_______Key xx
Night Service 0
__
55