Section 7 Test The System; Test The Sl2100 2W Digital Multiline Terminals; Test The Analog Terminals (Test Each Phone In Turn); Test The Ip Multiline Terminal (Test Each Phone In Turn) - NEC SL2100 Getting Started Manual

CPU card and the connected multiline telephone display shows the time and date and the
extension number.

Section 7 Test the System

Follow the procedures below to test the system.

7.1 Test the SL2100 2W Digital Multiline Terminals

Test each phone in turn.
1) Press Speaker.
If you hear system dialing tone the phone has initialized correctly. Press Speaker to clear.
If you do not hear dial tone, move to step 2.
2) Check the connections.
Check the connections from the phone to the SL2100. Ensure all 2 wires are connected as
shown in 5.1 2W Digital Multiline Terminal
3) Plug the phone into the ESI connection port at the 082U-B1 board.
(The RJ61 socket (ESI 1/5-ESI 4/8) has four 2W-digital extension ports, therefore if you
connect a multiline terminal directly to an RJ61 socket, you can get the first port instead of
four port. However if you need the four port, you need to consider the wiring.)
If you have used telephone cable and RJ11 sockets to extend the connections,
plug the phone directly into the ESI connection port at the 082U-B1 board using the line cord
supplied with the system phone.
If the phone does not initialize correctly, move to step 4.
4) Swap the phone
Try another digital multline terminal plugged directly into the ESI connection port using the
line cord supplied with the phone.

7.2 Test the Analog Terminals (Test each phone in turn)

1) Lift the handset.
If you hear system dial tone the phone has working correctly.
If you do not hear dial tone, move to step 2.
2) Check the connections.
Check the connections from the phone to the SL2100 to ensure both wires are connected as
shown in 5.2 Analog
3) Plug the phone into the SLT connection port at the SL2100 board.
If you have used telephone cable and RJ11 sockets to extend the connections,
plug the phone directly into the SLT connection port at the SL2100 board using the RJ11 line
cord.
(Ensure the line cord connections are correct).
If you do not hear dial tone when you lift the handset, move to step 4.
4) Swap the phone.
Try another analog terminal plugged directly into the SLT connection using the RJ11 line cord.

7.3 Test the IP Multiline Terminal (Test each phone in turn)

1) Lift the handset.
If you hear system dial tone the phone is working correctly.
If you do not hear dial tone or there is no display, move to step 2.
2) Check the connections
Check the connections from the phone to the SL2100 to ensure both LAN cables are
connected as shown in
3) Plug the phone into the VOIPDB connection at the VoIPDB board through the PoE HUB.
(Ensure the LAN cable connections are correct).
If you do not hear dial tone when you lift the handset, move to step 4.
4) Swap the phone.
Try another IP multiline terminal plugged into the PoE HUB using another LAN cable.
SL2100 GETTING STARTED GUIDE
(IP7WW-12/24TXH-B1).
Terminal.
5.3 IP Multiline Terminal (IP7WW-8IPLD-C1).
47