Automatic Side Tone Adjustment For Analog Trunks; Program 90-68-01 - NEC SL2100 Getting Started Manual

SL2100 GETTING STARTED GUIDE

2.15 Automatic Side Tone Adjustment for Analog Trunks

This setting must be used on every install of an SL2100 that has Analog trunks. This program will test the Analog
trunks and assign the proper system levels so that the lines and system will be evenly matched. During the
testing the system will be inoperable and after the test the system must be reset. It is recommended to do this
test before the system is cutover to not interfere with normal business.

2.15.1 Program 90-68-01

Below are the steps needed to run the automatic side tone adjustment program.
No. Operation
1 Log into Programming Mode.
If you have already logged into Programming Mode, skip this
operation.
2 Dial 90 68 01, Enter the trunk number (1 – 128).
3 Press the Hold key and the automatic line adjustments will start..
Note: While this test is being performed the system will not be
operational.
4 Once the test is completed you can copy the settings to all lines or
perform the test line by line.
To copy the settings to all lines press 1 and press the Hold key. After
pressing Hold, press the Mute key three times and then press the
Speaker key to save the changes and exit Programming Mode.
Note: If the settings have been copied to all lines, be sure and test all
lines after the system has been reset. If one of the lines is having
voice quality issues, run the test again for that specific line.
5 Perform a system Reset.
For the other features, refer the Features & Specifications Manual.
68
Display Shows;
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
90-68-01
Adjustment Start _
←
90-68-01
Measurement(1/5)
←
90-68-01
Copy ? (1:Yes)
←
→
→
→